22
3. While pushing booster against
vehicle seat, pull one adjuster
strap tight and then the other.
Make sure that both LATCH/UAS
connectors are securely attached
to the vehicle’s lower anchors.
4. Booster seat should rest
rmly on vehicle seat
bottom and touching
the vehicle seat back.
A gap is acceptable as
long as the head support is
touching the vehicle seat back or
headrest. The entire seat bottom should
sit at on the vehicle seat.
NOTE: Even with LATCH/UAS connectors properly
attached and adjusted, the booster seat will still have
movement against the vehicle seat back and bottom.
Disengage lower anchors by reaching under the bottom of
the booster seat and depressing the cam lock lever while
pulling the seat away from the vehicle seat back until the
lower anchor straps are extended all the way. Unhook
lower anchor connectors from car LATCH/UAS anchors.
FIRST SETUP
To Next Page
Loading...
