us.diono.com/installation-videos
1-855-463-4666
52
53
INITIAL SETUP
1. Place Your Child in the Seat
Make sure their back is flat against the car seat back.
(This can be done in or out of the car). Avoid bulky or
heavy clothing. Doing so will prevent the harness straps
from being tightened properly at first fitment.
2. Place Harness Straps Over Child’s Shoulders and
Buckle
You will hear a “click” when buckle tongues are
securely attached. Pull up on each buckle tongue to
make sure it is securely attached.
3. Be Sure the Harness Straps Are at the Proper Height
SECURING YOUR CHILD SECURING YOUR CHILD
HARNESS SETUP
1. Loosen Harness Straps
Lift up on the harness adjuster while pulling out on the
harness straps at the chest clip. Unbuckle the chest clip
and the center buckle. Place harness straps o to the
sides.
2. Place Your Child in the Seat
Make sure their back is flat against the car seat back.
Avoid bulky or heavy clothing. Doing so will prevent
the harness straps from being tightened properly.
3. Place Harness Straps Over Child’s Shoulders and
Buckle
You will hear a “click” when buckle tongues are
securely attached. Pull up on each buckle tongue to
make sure it is properly secured.
NOTE: Remember: The addition or removal of
clothing will change the fit of the harness, especially
bulky winter jackets. Diono recommends harnessing
your child first and placing a blanket over them or
putting their jacket on backwards.
To Next Page
Loading...
