EasyManua.ls Logo

Diono Rainier 2 AXT - Page 26

Diono Rainier 2 AXT
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
us.diono.com/installation-videos
1-855-463-4666
50
51
3
BOOSTER MODE
installation instructions
REAR FACING FORWARD FACING
BOOSTER MODE
BOOSTER MODE
BOOSTER MODE INSTALLATIONS:
50-120 lbs (22.7-54 kg)
WARNING! Use ONLY the vehicle lap and shoulder
belt system when restraining the child in this
booster seat. DO NOT use a lap belt only!
WARNING: Make sure vehicle seat belt has
properly retracted before use.
NOTE: If 5-Point harness is installed, please review
the harness removal section. The 5-point harness
MUST be removed to use this seat in booster
mode.
1. Place Child In Seat
Have your child sit in the booster seat, with his/her
back flat against the back of the booster seat.
2. Thread Vehicle’s Shoulder Belt Over Seat and
between inside of car seat shell and the belt guide
in the Headrest.
3. Buckle the Vehicle Lap/Shoulder Seat Belt
Be sure the shoulder belt lies across your child’s
shoulders, between the neck and edge of the
shoulder. Be sure the lap portion of the vehicle seat
belt goes under the side nubs and the belt lies low
across your child’s hips.

Related product manuals