us.diono.com/installation-videos
1-855-463-4666
48
49
FORWARD FACING
5. Tighten the Vehicle Seat Belt.
In most vehicles today, slowly
pull the shoulder belt all the way
out and then let it go back in. You
will hear a clicking sound as the
belt retracts. Slowly pull out on
the belt and it should be locked.
If not, please review your car’s
owner manual. Press down firmly
in the center of the car seat. Pull
on the shoulder belt to tighten
while feeding the slack back in the
retractor.
6. Tighten the Top Tether Strap.
Push the car seat back while
tightening the tether strap to
remove all the slack.
FORWARD FACING
7. Test For Tightness.
Grab the side of the seat on the
buckle side with one hand where
the LATCH strap is and slide the
car seat side-to-side and front-to-
back. If the seat moves less than 1
inch (2.5 cm), it is tight enough. Do
not test by grasping top of the seat.
To Next Page
Loading...
