Need help?Do you have a question about the Directed Audio 6550 and is the answer not in the manual?
Accepts line level outputs from head units or signal processors at voltages between 150mV and 8 volts.
Pass through RCA jacks used to send signal to a second amplifier.
Lights GREEN when the amplifier is on and operating normally.
Controls the gain of channels five and six from a remote location.
Connect the speakers to these terminals as per the wiring diagrams.
Protect the amplifier against internal electrical damage.
Connect this terminal through a FUSE or CIRCUIT BREAKER to the positive battery terminal.
Turns on the amplifier when (+) 12 volt is applied to it.
Connect this terminal directly to the sheet metal chassis of the vehicle.
Controls amplifier sensitivity to match input level to signal source output.
Controls the type of filter for the on-board active crossovers (FLAT, HPF, LPF).
Adjusts the crossover point for the on-board active crossovers.
Adds 8 db of additional boost to channels five and six output when active.
Controls input signal to channels, allowing derivation from other inputs.
Locates gain and filter controls; must be removed for access.
General| THD at Rated Power | <0.05% |
|---|---|
| Input Sensitivity | 200mV~6V |
| Subsonic Filter | 15Hz |
| Bass Boost | 0~18dB |
| Frequency Response | 10Hz~40kHz |
To Next Page