1111
©
2005 Directed Electronics—all rights reserved
QQUUIICCKK RREEFFEERREENNCCEE GGUUIIDDEE::
TToo rreemmoottee ssttaarrtt tthhee vveehhiiccllee
1. Press the auxiliary channel on the transmitter twice within 3 seconds.
2. The parking lights will flash to confirm remote start operation.
3. Once the vehicle has started, it will run for the pre-programmed period
of time or until a shut-down input is triggered.
TToo ppeerrffoorrmm VVaalleett TTaakkee--OOvveerr
1. Before turning off the engine, press and release your auxiliary channel
button on the transmitter twice within 3 seconds (or press and release
the optional momentary switch).
2. Turn the ignition key to the OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or a shut-
down input is received.
TToo eenntteerr TTiimmeerr MMooddee
1. Turn the ignition on.
2. Press the auxiliary channel button controlling remote start twice within
3 seconds.
3. Turn the ignition off while holding the auxiliary channel button.
UUssiinngg RReemmoottee SSttaarrtt wwiitthh FFaaccttoorryy RReemmoottee SSyysstteemmss
■ If this remote start system has been interfaced with an original equip-
ment from manufacturer (OEM) factory remote system, the Remote
Start/Valet Take-Over sequence can be programmed to initiate with one
to three (1-3) presses of one of the OEM transmitter buttons. Factory
default is 2 presses.
OOEEMM ttrraannssmmiitttteerr bbuuttttoonn uusseedd ffoorr RReemmoottee SSttaarrtt//VVaalleett TTaakkee--OOvveerr
sseeqquueennccee____________________________________________________________________________________________
NNuummbbeerr ooff OOEEMM ttrraannssmmiitttteerr bbuuttttoonn pprreesssseess rreeqquuiirreedd ttoo iinniittiiaattee
RReemmoottee SSttaarrtt//VVaalleett TTaak
kee--OOvveerr sseeqquueennccee________________________________________
CCuutt aalloonngg ddootttteedd lliinnee aanndd ffoolldd ffoorr aa qquuiicckk aanndd eeaassyy rreeffeerreennccee ttoo kkeeeepp iinn yyoouurr ppuurrssee oorr wwaalllleett..
✂
✂