Directed Electronics SmartStart - User Manual

TWO-WAY LCD AUTOMATIC/MANUAL
TRANSMISSION REMOTE STARTER WITH
FULL ALARM SYSTEM
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 110916 Rev:1.8 © 2011 -2W-FM-LCD-CMB-HD- -PGa+FcN- Canada
______________
User Guide
WARNING !
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Battery Low Voltage Warning
Once the battery is weak, the LCD remote will display a battery low voltage icon
and an “L-BAT” indication with 2 beeps to warn the user to charge it.
Designed & engineered in Canada
SYSTÈME BIDIRECTIONNEL DE DÉMARRAGE À
DISTANCE À AFFICHAGE À CRISTAUX LIQUIDES
POUR TRANSMISSION AUTOMATIQUE/MANUELLE
AVEC SYSTÈME D’ALARME COMPLET
AVIS D’INDUSTRIE CANADA :
L’utilisation de cet appareil est sujette aux deux conditions suivantes : 1) cet appareil ne doit causer aucune interférence
nuisible; 2) cet appareil doit accepter toute interférence qui pourrait nuire à son fonctionnement.
Pour réduire le brouillage radioélectrique qui risque d’affecter d'autres utilisateurs, il est important de choisir le type et le gain
de l'antenne de façon que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas ce qui est nécessaire pour
assurer une communication efficace.
REMARQUE : Le fabricant ne peut être tenu responsable du brouillage radioélectrique causé par des modifications non
autorisées apportées à l’appareil. De telles modifications pourraient annuler le droit de jouissance de l’utilisateur de cet
appareil.
Doc#: 110916 Rev:1.8 © 2011 -2W-FM-LCD-CMB-HD- -PGa+FcN- Canada
_______________
Guide de l’utilisateur
ATTENTION !
Il est de la responsabilité du conducteur du véhicule de s’assurer que celui-ci
est stationné de façon convenable et sécuritaire.
1. a) Transmission manuelle
: L’utilisateur doit s’assurer que le levier de vitesse
est à la position NEUTRE et que le frein de stationnement est appliqué de
façon adéquate avant de quitter le véhicule afin d’éviter tout dommage au
moment du démarrage à distance.
b) Transmission automatique
: L’utilisateur doit s’assurer que le levier de
transmission est en position « Park » avant de quitter le véhicule afin d’éviter tout
dommage au moment du démarrage à distance.
(Note : Assurez-vous que le véhicule à transmission automatique ne peut pas
démarrer lorsque le levier de transmission est en position « Drive »).
2. L’utilisateur doit s’assurer de désactiver le démarreur à distance ou de le mettre
en mode valet avant de confier véhicule à un mécanicien ou un technicien
affecté à l’entretien.
Avis au sujet de la pile de la télécommande
Lorsque la pile deviendra faible, une icône de basse tension et l’indication « L-BAT » s’afficheront sur l’écran
ACL. 2 bips se feront aussi entendre, indiquant à l’utilisateur que la pile doit être chargée.
Conçu au Canada

Summary

WARNING!

Battery Low Voltage Warning

Informs the user about low battery status on the LCD remote with visual and audible alerts.

INDUSTRY CANADA USER NOTICE

Government regulations

Introduction with SmartStart

Vehicle Presets

Using the Transmitter

LCD Remote Functions

Describes the various functions of the LCD transmitter, including command confirmation and timer features.

LCD Transmitter basic confirmations

Backlight

Charging the Battery

Remotes advanced functions and MENU

How to access advanced remote functions and MENU

Step-by-step instructions on entering the remote's menu and navigating through its advanced features.

Remotes advanced functions and MENU table

Remote Starting Your Vehicle

Setting Your Vehicle in to Ready Mode

Details the crucial steps to put the vehicle into "Ready Mode" for remote starting, especially for manual transmissions.

Remote Starting

Driving Off

Arming and disarming of the System

Intrusion alert via remote

Describes how the remote notifies the user of intrusions via door, hood, trunk, or shock events with LCD text and icons.

Remote Starter Features

Remote Door Locks

Details the convenience of remote keyless entry for locking and unlocking vehicle doors.

Remote Trunk Release

Explains how to remotely open the vehicle's trunk and its effect on the alarm system.

Idle Mode

Describes the Idle Mode feature, allowing the engine to run with doors locked for short stops.

NEW FEATURE - Push-To-Start Idle Mode

Valet Mode

Valet Mode

To put the system into Combo Valet

Details methods to enter Combo Valet mode using the ignition key, transmitter, or valet switch.

Panic Mode

Quick Lockout

Cold Weather Mode

Extended Run Time

Intrusion Codes via LED light

Car Finder

Temperature Request (If ACC-Temp-101 installed)

Temporary Chirp Delete

Relock

Missing a Start or a Stop Confirmation

Advanced Features: Installation-programmable Options

Ignition-Controlled Door Locks

Details the security feature that automatically locks doors upon ignition activation and unlocks them upon shutdown.

Secure Lock

Home Valet Mode

Safe Start

Engine Run Time

Turbo Mode

Siren Chirps

Arming

Shock Sense & Warn Away sense

Priority door

Multi-car Operation

Multi-Level Features (default state)

Troubleshooting Transmitting Range

Troubleshooting Transmitting Range

Diagnostics - Parking Light Flash Table

Diagnostics - Parking Light Flash Table

Troubleshooting Transmitting Range

Diagnostics - Parking Light Flash Table

Directed Electronics SmartStart Specifications

General

Smartphone Control	Yes
Valet Mode	Yes
Type	Remote Starter
GPS Tracking	Yes
Security System Integration	Yes
Remote Start Confirmation	Yes
Keyless Entry	Yes
Engine Status Alerts	Yes
Battery Voltage Monitoring	Yes
Mobile App	Yes
Subscription Required	Yes