EasyManua.ls Logo

Directed Electronics AS-1775 User Manual

Directed Electronics AS-1775
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
5BUTTONAUTOMATIC/MANUALTRANSMISSION
REMOTESTARTER
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Doc#: 110705 Rev:1.8 © 2011 - AS-1775 - - FcN - Canada
AS-1775
User Guide
WARNING
!
It is the responsibility of the vehicle operator to ensure that their
vehicle is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Designed & engineered in Canada
Question and Answer IconNeed help?

Do you have a question about the Directed Electronics AS-1775 and is the answer not in the manual?

Directed Electronics AS-1775 Specifications

General IconGeneral
BrandDirected Electronics
ModelAS-1775
CategoryRemote Starter
LanguageEnglish

Summary

Using the Remote Control

Starter Kill Arming/Disarming

Procedure to arm and disarm the starter kill security feature using the key.

Remote-Starting Your Vehicle

Setting Ready Mode

Steps required to put the vehicle into Ready Mode for remote starting, essential for manual transmissions.

Remote Start and Driving Off

Instructions on initiating remote start, stopping the engine, and driving the vehicle.

Remote Starter Features

Valet Mode

Valet Mode Activation/Deactivation

Procedures to enable and disable Valet Mode via ignition key or transmitter.

Safety & Special Modes

Panic Mode

Emergency activation to sound horn and control door locks, separate from remote start.

System Configuration & Advanced Features

Auxiliary Functions & Alarms

Troubleshooting & Reference

Poor Transmitting Range

Identifying and resolving issues related to limited remote transmitter range.

Related product manuals