DIRECTV PLUS
®
DVR USER GUIDE
48
My Playlist - Multi-Room Viewing
High-Definition Receivers
2. Activate Multi-Room HD DVR Service:
Once Multi-Room HD DVR Service is activated on your account, press
the LIST button on your remote. The message on the right will display,
confirming the service has been enabled. Select “Continue”.
3. Name Your Locations:
You’ll be prompted to give each receiver a name. We refer to this as
“Location”. We recommend using a name that you’ll easily associate
with the room or it’s location, such as, “Living Room.” The name must
be 14 characters or less. You must be at the receiver to assign its
name.
Note: Service activation and location naming are typically performed by the
installer during your installation appointment.
After you’ve assigned a Location Name, you can change it as follows:
Press MENU, select “Parental, Fav’s & Setup,” “System Setup,” “Multi-
Room” and then “Name Location.”
To Next Page
Loading...
