HOW TO INSTALL / OPERATE THE MACHINE
BEFORE YOU START
• Always switch off and unplug the vacuum cleaner before
connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for
any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens,
switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container and also check
the vacuum cleaner for blockages. Allow the vacuum cleaner
to cool for approximately 1 hour (if you have cleaned the lters
please wait 24 hours for the lters to fully dry before putting
back into the machine).
• Clean the pre-motor lter every time the dirt container is
emptied and replace the lters every 12 months.
• If the vacuum cleaner is blocked, switch off and unplug before
removing the blockage.
• When using the accessories always make sure the brush bar is
switched to the off position.
IMPORTANT: The base of the vacuum cleaner should always
be positioned at on the oor when starting and in use. The
dirt container should be locked into place before lifting the
vacuum cleaner by the carry handle.
ASSEMBLING YOUR MACHINE
IMPORTANT: The condition of the lters affects the
performance of your machine. Please check and clean lters
periodically (depending on the level of use). For full cleaning
instructions, see ‘taking care of your machine’.
To Next Page
Loading...
