Dirt Devil DD2505 - Page 8

16. Tap the pre-motor lter against a bin to remove any dirt/debris.
17. Rinse the pre-motor lter under water (max 40 °C).
18. Leave to dry for 24 hours or until fully dry before placing back
in the machine.
CLEANING THE SHROUD
19. Hold the dirt container and twist the lid anti-clockwise.
20. Lift the lid to reveal the pre-motor lter.
21. Lift out the pre-motor lter.
22. Twist the separator cap anti-clockwise to unlock and remove.
23. Lift and remove the separator from the dirt container.
24. Tap the separator against a bin to remove any dirt/debris.
25. Make sure the rectangular hole in the dirt container lines up with
the rectangular hole on the separator.
26. Replace the separator cap, twist clockwise to lock.
27. Replace the pre-motor lter. Close dirt bin lid making sure it clicks
and locks into place.
Note: For easier cleaning, follow the 3-step clean process
located on the back of the dirt container. Don’t over ll the dirt
container. Replace the lters every 6-9 months.