PLACING DIRTY WATER TANK IN BASE
OF
CLEANER:
Lift front base of cleaner off
carpeting with one hand.
While making sure the front
of the dirty water tank is rest-
ing on the base, place the
rear of the tank into the base
of the cleaner. Push handle
down until
it
latches (Diagram
8).
NOTE: Do not store cleaner with
solution in reservoir or dirty
water in dirty water tank Mineral
deposits and mildew can form
which will affect the performance
of your
Featherlitee Carpet
Shampooer.
Grasp handle and hook front of dirty water tank into base of cleaner,
making sure front of dirty water tank is resting on the base (Diagram
2). The Dirty Water Tank has
3
tabs on the underside which
MUST
latch into the underside of the base of the cleaner. It is very important
to lift the base of the cleaner off of the carpeting and hook the nozzle
to the base so that the nozzle is flush with the base of the cleaner
(Diagram 2a). Failure to install the Dirty Water Tank correctly (Diagram
2b), will result in poor dirty water pickup. The Dirty Water Tank will
need to be emptied once or twice per fill up of the Clean Water Tank.
To Next Page
Loading...
Need help?
General
