Dirt Devil ND40100 - Vacuuming Liquids

HOW TO OPERATE: CONTINUED
22
22
2. To maintain peak performance of your vac when picking up small debris such as
sawdust, it may be helpful to empty the dust drum and clean or replace the lter
at more frequent intervals.
NOTE: The lter should be dry to pick up dry material. If you use your vac to pick up
dry debris when the lter is wet, the lter will clog quickly and be very difcult to
clean. In case the lter gets wet, replace it before continuing dry pickup.
Vacuuming Liquids
1. Removal of the lter is highly recommended for wet pickups.
2. This wet/dry vac is equipped with a float mechanism which will rise automati-
cally to cut off the airflow when the liquid in the drum reaches a predetermined
level. When this happens, turn off vac, unplug the power cord, and empty the
dust drum. You will know that the float has shut the airflow off because the suc-
tion ceases and the motor noise becomes higher in pitch, due to increased motor
speed. The liquid capacity may vary with the rate of pickup.
3. Be sure to replace lter after wet pickup. Never pick up dry debris without the
lter properly installed.
IMPORTANT: To reduce the risk of damage to the vac, do not run motor with float in
raised position.
FILTER TYPE: 55
WARNING: Never leave vac running while unattended.
WARNING: To reduce the risk of injury from accidental starting, unplug power
cord before emptying the tank.
Filter
Retainer
Band
Float In
Raised
Position
Emptying the Tank
1. Place vac squarely on a stable surface, such as ground, floor, bench, etc.
2. Remove the power head assembly of the wet/dry vac by pulling outward on the
latches located on each side of the vac. Lift off the motor housing assembly.
3. Dump the tank contents into the proper waste disposal container.
AVERTISSEMENT : Ne pas retirer le boîtier ni le flotteur. Le flotteur empêche
le liquide de pénétrer dans la turbine et d’endommager le moteur. Le boîtier
empêche les doigts de l’utilisateur d’entrer en contact avec la turbine.
GUIDE DE DÉPANNAGE
Nettoyage
Pour nettoyer le réservoir :
1. Éliminer les débris.
2. Nettoyer à fond le réservoir à l’eau chaude savonneuse.
3. L’essuyer à l’aide d’un linge sec.
Rangement
Avant de ranger l’aspirateur, le réservoir doit être vidé et nettoyé.
PROBLÉME CAUSE POSSIBLE SOLUTION
L’aspirateur ne
ramasse pas la
poussière
1. Filtre obstrué.
2. Le tuyau est
obstrué
3. Fuite d’air
1. Nettoyer ou remplacer le ltre.
2. Retirer le tuyau et enlever les débris.
3. Veiller à ce que le bloc-moteur soit bien xé au
réservoir à poussière.
L’aspirateur ne
fonctionne
pas
1. Aucune
alimentation
électrique
1. S’assurer que la prise de courant est sous
tension. (Consulter un électricien qualié au
besoin.)