Using your machine
Operating the appliance
Adjust the Variable Power Dial to
increase or decrease the suction.
Fully unwind the power cord.
A yellow mark on the cord
indicates the recommended cord
length. Do not exceed the cord
length beyond the yellow mark.
1
2
Taking care of your machine
Turn on the mains power supply,
then press the On/Off Button
on the vacuum to turn on the
vacuum.
Assembling your vacuum cleaner
NOTE: The floor head and 2-in-1 tool can all be attached directly to the extension tubes or hose handle.
NOTE: The floor tool may be difficult to move on some carpeted surfaces, adjust the Air Relief Valve on the hose
handle to reduce the suction pressure.
Hard floors
Carpets
Insert the hose into the hose inlet
on the vacuum until it clicks into
place. To remove the hose, press
the locking tabs on either side of
the hose connector and gently
pull.
Gently insert the handle into the
extension tubes and push until it is
secured into place.
Insert the opposite end of the
extension tubes into the floor
head. The floor head is ideal for
daily cleaning on carpets and hard
floors.
To Next Page
Loading...
