Dirt Devil Swivel Glide - Troubleshooting Guide; Cleaner Not Running; Cleaner Wont Pick-up or Low Suction; Dust Escaping from Cleaner

TROUBLESHOOTING GUIDE
Problem
Cleaner won't run
Cleaner won't pick-up
or low suction
Dust escaping from cleaner
stallation
- Pg. 5.
Cleaner tools won't pick up
Belt burns or breaks
IMPORTANT: UNPLUG CLEANER BEFORE SERVICING
Possible Reasons I Possible Solutions
1. Paper bag is not opened.
2. Paper bag full.
3. Brushroll wm.
4. Broken or worn beL
5. Clogged filter pad.
6. Nouleldirt passage clogged.
1. Power cord not firmly plugged into outlet
1.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Motor Protector tripped.
1.
Insert finger into hole and push paper away from opening.
2. Replace paper bag - Pg. 7.
3. Replace brushmll- Pg. 8.
4. Replace belt
- Pg. 8.
5. Replace filter - Pg. 7.
6. Remove base nozzle cover - Pg. 8; remove obstruction
Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuselreset breaker.
3. Take to service center or call 1-800-321-1 134.
4. Clog indicator light - Pg. 3.
7. Carpet height setting is incomct
8. No paper bag.
1. Paper bag full.
2. Bag not installed correctly.
3. Pundureltiole in paper bag.
4. No bag in cleaner.
5.
I.
2. Loose electrical wires. 2. Call 1-800-321-1 13th nearest authwized Royal Dealer.
1. Replace paper bag - Pg. 7.
2. R eview paper bag installation - Pg. 7.
3.
Replace paper bag
- Pg.7. CleanlReplace Filter - Pg. 7.
4. Install bag &clean filter - Pg. 7.
Hose not installed correctly.
5. Review Hose
1. Hose clogged.
2. Bag inlet clogged.
1. Remove hose and tools; remove obstruction
- Pg. 3.
2.
Remove hose & paper bag and clean inlet - Pg. 3,7.
1. Brush may be jammed with debris.
2. Brush end caps are clogged with debris.
7
, . #.
4. No bag in deaner ,filter dogged.
4. Install paper bag & clean filter - Pg. 7.
1 Camp- . ..
3. Carpet Height Setting is incorrect.
1 S~tr~e . .
setting for carpet being cleaned - Pg. 6.
I
1. Remove brush - Pg. 8. Clean brush of debris.
2. Remove brush. Determine
if end caps rotate freely. If
not, replace brushroll
- Pg. 8.
. Set Carpet Height adjustment to appropriate setting for
carpet being cleaned
- Pg. 6.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE
(1 -800-321 -1 134)
In the event that further assistance is required, see your Yellow Pages for an authorized ~byal
@ Dealer. Costs 6f any hnsprtation to and from
any place of repair are to
be paid by the owner. The service parts used in this unit are easily replaced and readily available
from an authorized
RovaP Dealer or retailer.
Always identifv vour deaner bv the model number and manufaclurina code when reauestina information or or
denna
I number amears on the &I& of the cleane
. < " 8."- - -
reolacement mtts. (The mode
r.
)