Displays2go HVAWM4290L User Manual

1
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE! IF
YOU DO NOT UNDERSTAND THE INSTRUCTIONS, OR DO NOT FEEL THAT YOU CAN FOLLOW
THEM SAFELY, CONTACT A QUALIFIED CONTRACTOR. THE WARRANTY WILL BE HONOURED IF
ACCOMPANIED BY AN ORIGINAL SALES RECEIPT, AND ONLY IF THE INSTRUCTIONS HAVE
BEEN FOLLOWED EXACTLY.
·
The HVAWM4290L
is designed to mount a panel onto a vertical wall. Hardware for mounting to
a wood stud is included. For mounting to any other surface, it is recommended you contact a
qualified contractor.
· The wall or mounting surface must be capable of supporting the combined weight of the mount
and the display, otherwise the structure must be reinforced.
· Safety gear and proper tools must be used. A minimum of two people are required for this installati
on.
Failure to use safety gear and/or attempting this installation alone can result in property damage,
serious injury, or death.
· Follow all instructions and recommendations regarding adequate ventilation and suitable locations for
mounting your flat panel. Consult the owner
‘s manual for your flat panel for more information.
· This product will hold flat panels up to 90” and weighing up to 200 lbs.
· VESA 800mm x 600mm
Tools Required
· Stud finder ("edge to edge" stud finder is recommended)
· Phillips screwdriver
· Pencil
· Hammer Drill (Concrete installation only)
· 1/4" drill bit for wood studs, 3/8” drill bit for concrete
· 7/16" socket wrench or bit driver for wood screws
· Level
· Tape measure
INSTRUCTIONS
HVAWM4290L
Parts List
Wall Plate (x1)
Adaptor Plate (x1)
Adaptor Brackets (x2)
Slider Plates
(x4)
Anchor (x4)
Spacers (x4)
Allen Key (x1)
M5*15mm
(x4)
M5*25mm
(x4)
M6*12mm
(x8)
M6*25mm
(x4)
M8*15mm
(x4)
Lag Bolt
8*70mm (x4)
A
M8*15mm
(x4)
B
M8*30mm
(x4)
C
Metal Washer
φ8mm (x4)
D
Metal Washer
φ6mm (x8)
E
F
G H
I
J
K
L
M
N

Displays2go HVAWM4290L Specifications

General

Brand	Displays2go
Model	HVAWM4290L
Category	TV Mount
Mount Type	Wall Mount
Compatible Screen Sizes	42" - 90"
Material	Steel
Color	Black
Tilt	Yes
VESA Compatibility	600x400
Swivel Range	90°
Tilt Range	-15 to 5 degrees

Summary

Mounting the Wall Plate

Mounting the wall plate to wooden studs

Steps for mounting the wall plate to wooden studs using appropriate hardware and tools.

Mounting the wall plate to concrete

Steps for mounting the wall plate to concrete or masonry surfaces using anchors.

Assembling and Attaching the Mount

Assembling the Adaptor Plate

Instructions for assembling the adaptor plate with rails, brackets, and screws.

Attaching the flat panel to the mount

Procedure for attaching the flat panel to the mount using specific screws and washers.

Adjusting the Flat Panel

Using cable management

Guide on utilizing the integrated cable management system for neat routing.

Roll Control

Instructions for horizontal leveling (roll control) of the flat panel display.

Tilt Adjustment

Procedure for adjusting the screen's vertical angle (tilt) for optimal viewing.

Swivel and Panning

Adjusting the display for off-center viewing (swivel) and room-wide viewing (panning).

Portrait and Landscape Viewing

Guidance on rotating the display between portrait and landscape orientations.

Retracting the flat panel

Steps to position the panel against the wall into a retracted state.

Maintaining the HVAWM4290L