4 / 11
1. Using the cutout sheet provided at the end of this document, trace and cut an opening in the panel door.
IMPORTANT
: The cutout sheet must be printed in “actual size” to preserve the scale of the template.
2. Pull all cable (power supply, Ethernet, etc.) through the panel cavity.
3. Connect all wiring to the HORYZON display, power supply last.
4. Insert the HORYZON display into the cavity.
5. Mount the supplied fixing brackets on the back of the HORYZON display.
6. Tighten the fixing brackets (recommended torque 0.7 N m)
Figure4: HORYZON Panel Mounting
Wall Mounting Installation Procedure
This product can be mounted on a dry wall using the optional wall-mounting kit.
This mounting method provides an IP20 environmental rating.
7. Position the in-wall mounting box on the wall and trace the outline.
8. Make a cavity in the dry wall according to this tracing.
9. Fasten the anti-theft cable lock to the wall-mounting box using the provided Torx screw.
10. Pull all cables (power supply, Ethernet, etc) out of the wall cavity and through the mounting box.
11. Insert the wall mounting box into the cavity
12. Push out the appropriate pre-punched zones to ensure a tight fastening of the box.
13. Connect all wiring to the HORYZON display, power supply last.
14. Fasten the anti-theft cable lock to the HORYZON display using the provided Torx screw.
15. Insert the display into the in-wall mounting box, starting with the bottom side to fit the drawings
16. Push the display into the in-wall mounting box and make sure it clips tightly into place.
In-wall mounting box dimensions
£ HORYZON-C7 In-Wall Mounting Kit
182.5 x 119.5 x 50 mm
112.7
(4.44)
112.2
(4.42)
50
(1.97)
0.5
(0.02)
176.3 (6.94)
177.3 (6.98)
119.5
(4.70)
182.5 (7.19)
mm(inches)
To Next Page
Loading...