To Next Page

To Previous Page

750/752 Tracker - CONTROLS 9

CONTROLS

750/752 Tracker - CONTROLS 9

CONTROLS

Depth + On/Off

Pressing these buttons when tracker is on cycles volume from

low to high to off. Pressing and holding depth button before

turning tracker on changes signal strength display. See “Signal

Strength” section later in this chapter for more information.

Depth + Fore/Aft/Left/Right

Pressing these buttons switches LCD backlight off and on.

Depth + Up

Pressing these buttons enters tracker into calibration mode. See

OPERATION for further information.

Depth + Down

Pressing these buttons selects radio channel. 750 - Off, CH1,

CH2 will appear in display. 752 - Off, CH1, CH2, CH3, CH4, CH5,

CH6, CH7, CH8, CH9 will appear in display.

Depth + Mode

Pressing these buttons changes depth units from default setting

of feet•inches to inches, centimeters, or meters.

Down + On

Holding down button while turning unit on toggles gain control

from auto to manual. Display will show “Auto” if in automatic gain

mode, and will be blank if in manual gain mode.