SK500 Operator’s Manual Controls - 19
CMW
7. Hydraulic fluid
temperature indicator
Lights when hydraulic fluid is
overheating.
Check hydraulic fluid level.
8. Attachment drive
control
To engage attachment drive
in reverse, push up.
To engage attachment drive
in forward, pull down.
9. Lift arm control To move lift arms down, push.
To float, push forward to end.
To move lift arms up, pull.
To curl attachment up, move
to left.
To curl attachment down,
move to right.
IMPORTANT: Do not exceed rated
operating capacity when lifting loads.
See page 65.
10. Throttle To increase engine speed,
push.
To decrease engine speed,
pull.
Increasing engine speed also
increases attachment speed.
Item Description Notes
c00ic009c.eps
c00ic010c.eps
To Next Page
Loading...