SK600 Operator’s Manual Service - 75
Procedures
Oil, Engine
Check before startup and every 10 hours. Change at 50 hours and every 100 hours thereafter.
Check
1. Check level at dipstick (2).
2. Add DEO at fill (2) as needed to keep level at
highest line on dipstick.
Change
1. While oil is warm, remove plug (3) to drain.
2. Install plug.
3. Remove filter (4) and replace with new filter.
4. Add DEO at fill to keep level at highest line on
dipstick.
Radiator/Hydraulic Fluid
Cooler
Check radiator every 50 hours. Clean as needed.
Check
Check radiator (shown) for dirt, grass, and other
debris. Check radiator hoses for wear. Check hose
clamps for proper tightness.
Clean
1. Clean fins with compressed air or spray wash.
2. Open rear hood and spray through radiator toward engine.
3. If grease and oil are present on radiator, spray with solvent and allow to soak overnight.
NOTICE: Radiator may need to be cleaned
more frequently in dusty or grassy conditions.
NOTICE: Do not damage fins with high pressure air or water.
t51om007w.eps
1
2
3
4
t51om040w.eps
To Next Page
Loading...
