SK650 Operator’s Manual Prepare - 35
Connect Attachment
CMW
Connect Attachment
Attachment
1. Position attachment on level surface with enough
space behind it to accommodate unit.
2. Ensure that lock pin handles (shown) on mount
plate are turned away from center of attachment.
3. Start engine.
4. Tilt mount plate (2) forward.
5. Position mount plate in the upper lip of the receiver
plate (1) on attachment.
6. Raise lift arms while tilting back mount plate.
7. Turn ignition switch off and remove key.
8. Rotate lock pin handles toward center of mount plate
to secure attachment to lift plate.
IMPORTANT: Use only Ditch Witch-approved attachments. Attachments can change the stability and
operating characteristics of the unit.
IMPORTANT: Before connecting attachment to unit,
ensure that mount and receiver plates are free of dirt
and debris.
IMPORTANT: Attachment should be raised
enough to clear the ground. Mount plate
should be tilted back fully.
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
NOTICE: To ensure proper connection, verify that bottoms of lock pins are visible under
attachment receiver plate (shown).
t05om022c.eps
t05om026c.eps
12
t05om027c.eps
To Next Page
Loading...
