Service - 58 SK650 Operator’s Manual
Startup/10 Hour
CMW
Lube Front Track Idler Rollers
Use MPG to lubricate front track idler rollers at
startup and every 10 hours. Pump MPG into
zerks until grease is visible.
Check Coolant Level
Check coolant level, with engine cool, at overflow
bottle at startup and every 10 hours. Maintain
coolant level at halfway point on bottle. If low, add
approved coolant.
Note: The purpose of this lubrication is to
displace water, dirt, and mud from the idler
assembly. If working in very wet conditions,
use a waterproof lubricant.
IMPORTANT: See page 55 for information on
approved coolants.
t18om060t.eps
To Next Page
