DITEC GOL4-C - How to Erase Remote Controls; Erasing All Remote Controls; Erasing a Single Remote Control

!!!"#$$%&'(%)'*%+),%$"-%(.
.
!
• To erase your remote controls:
1. Press the programming button (PRG) on your receiver. Keep it pressed down. The LED light
on the receiver illuminates.
2. To erase all your remote controls, press the button PRG again for 3 seconds.
3. To erase only one remote control, press the buttons you use on your remote control.
4. The LED light on the receiver blinks fast.
5. The remote controls are erased.