14
Post-Dive Procedures
After diving with your DPV, rinse the scooter clean, then run the DPV for a few seconds while pressing the trigger a few times to release any additional water
buildup. After that, wipe or use compressed air to spray the scooter dry and remove the batteries, being careful not to allow drips or seepage into the scooter
body and battery ports. It’s important to do this as soon as possible after diving, and never store your batteries in your scooter. The small power draw of the
scooter will eventually drain the batteries and potentially damage them. Store your scooter in a warm, dry location.
To Next Page
Loading...