Dixon CE RAM User Manual

1
Setup
Uncrate machine.
ROPS Assembly
(Roll Over Protection System)
ROPS Assembly Components
1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2’’ Latch Pins w/lanyard
6 - 1/2C x 3 1/4’’ Cap screws
6 - 1/2C Centerlock Nuts
2 - Knobs
(all hardware Grade 5).
1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.
a. Locate the LEFT and RIGHT side posts.
b. Slide the left side post into the left side
receiver on the frame, do the same on
the right side.
c. Using 1/2C x 3 1/4 cap screws, two per
post, align the holes in the side post with
the frame receiver.
d. Install the 1/2C centerlock nuts finger tight
to the side post bolts.
3. Install roll bar top loop.
a. Align the holes of the top loop with the left
and right side posts.
b. Slide the latch pins through the front hole
on the left and right side to connect the
top loop to the side posts. Secure with
the hairpin.
c. Using 1/2C x 3 1/4 cap screws through
the rear hole on the left and right side.
d. Install the 1/2C centerlock nuts finger
tight.
4. Torque all 1/2’’ hardware to 80 ft./lbs. (110 N•m).
5. Install and tighten knobs against the side
post.
Set-Up Instructions
for CE RAM Models
PART NO. 539 130502 REV. IR (01/25/07)
1. Latch Pin
2. Top Loop
3. Knob
4 1/2C x 3 1/4 Cap Screws
5. 1/2C Centerlock Nuts
6. Right Side Post
7. Left Side Post
1
2
3
4
5
6
7
5
4

Dixon CE RAM Specifications

General

Engine	Briggs & Stratton
Displacement	190 cc
Cutting Width	21 in
Cutting Height	1.25-3.75 in
Engine Type	4-Cycle
Deck Material	Steel

Summary

Setup and ROPS Assembly

ROPS Assembly Instructions

Detailed steps for assembling the Roll Over Protection System (ROPS).

Safety Instructions

General Operation Safety

Core safety rules for operating the mower.

Personal Safety Equipment

Recommended protective gear for safe operation and maintenance.

Slope Operation Safety

Precautions for operating on slopes to prevent accidents.

Children Safety

Rules and warnings regarding children's safety around the machine.

Gasoline Handling

Precautions for storing, handling, and refueling with gasoline.

Operation Procedures

Starting the Engine

Step-by-step guide to starting the mower engine.

Maintenance

Maintenance Schedule

Overview of scheduled maintenance tasks and intervals.

Engine Oil and Filter Change

Blade Checking and Replacement

Adjusting the Mower Deck