SPECIFICATIONS
17
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Additional information may be provided elsewhere in this manual.
CHASSIS: 11 GA welded channel frame
BODY: All body parts made of rotational molded polyethylene.
Front body contains access panel for battery service.
Seat tilts forward to allow transmission service.
MOWER DECK: 11 GA stamped steel construction. Single 30 cut blade.
Cut height approximately 1-1/2- 4 via 7-position lift
handle.
BLADE DRIVE: Mechanical; hand lever engagement
TRANSMISSION: Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
ENGINE: 11HP Briggs & Stratton I/C, 4-cycle, single cylinder, air-
cooled, gasoline, vertical shaft, aluminum head and block.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on
parking brake and blade drive.
TIRES: Front 9 x 3.50-4 Smooth Tread
Rear 16 x 6.50-8 Turf Saver
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 3 quart
Engine 1.25 quarts oil
DIMENSIONS: Width 32 outside rear wheel measurement
Width 40 overall width of deck with deflector
Height 31 to top edge of seat
Length 65.5 hitch tab to front
Weight 390 lbs.
To Next Page
Loading...
