Dixon ZEETER - Troubleshooting Drive and Cut Quality

47
TROUBLESHOOTING
6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD
Drive belt broken or slipping- - - - - - - - - - - - - - - - replace drive belt
Damaged transmission- - - - - - - - - - - - - - - - - - - - - -consult dealer
7.
MOWER LOSES POWER OR TRANSMISSION OVERHEATS
Engine air filter-- - - - - - - - - - - - - - - - - - - - - - - - - - clean or replace
Transmission damage- - - - - - - - - - - - - - - - - - - - - - -consult dealer
8. ENGINE STALLS WHEN BLADES ARE ENGAGED
Operator not on seat- - - - - - - - - - - - - - - - - - - - - - - - - -sit on seat
Faulty interlock system- - - - - - - - - - - - - - - - - - - - - - consult dealer
Fauty blade spindle bearing - - - - - - - - - - - - - - - - - - consult dealer
Deck drive belt not properly routed- - - - - - - - - - - - - - - - - - reroute
Blades blocked by foreign material - - - - - - - - - - - clean under deck
9. DRIVE SYSTEM
Mower pulls to side- - - - - - -check tire inflation/adjust control linkage
Mower creeps in neutral- - - - - - - - - - - - - - - - adjust control linkage
Low on power- - - - - - - - - - - - - - - - - - - - - - - - - -check belt tension
10. CUT QUALITY
Cut uneven left to right- - - - - - - - - - - -check tire inflation/level deck
Ends of grass blades are ragged- - - - - - - - - - - - - - sharpen blades
Poor dispersal of grass- - - - - - - - - - clean deck/check for loose belt
Skips in spots- - - - - - - - - - -check for loose belt/slow ground speed