CARE AND MAINTENANCE
43
NEUTRAL SPRING ADJUSTMENT:
1. Loosen set screws on center spring stop collar
located on the control rods. (Requires a 1/8”
Allen wrench).
2. Swing control lever out. Tighten set screw on lock
collar.
3. Repeat for opposite side.
4. Engage parking brake and lower seat frame.
Release parking brake and swing control levers in. If
wheel creeps, repeat steps 1 and 2.
5. Stop engine and remove rear of machine from jack or
blocks.
6. Return the seat to the operating position.
7. Drive machine with both levers in top speed position.
If one side now drives slightly faster than the other
adjust forward speed bolt in to contact stop sooner.
To Next Page
Loading...
