DJ-Tech DJM-303 - Effect Parameters

ENGLISH
DEUTSCH FRANÇAIS
ESPAÑOL
DUTCH
ITALIANO
8
EFFECT PARAMETERS
Name BEAT/BANK button parameters
Parameter X
(Beat button)
Setting range (unit)
Parameter Y
(Level/Depth fader)
ECHO
Sets delay time of 1/2 to 4/1 per 1
beat of BPM time
2~2000 (ms)
Sets balance
between original and
delay sound
TRANS
Sets change time of 1/2 to 4/1 per
1 beat of BPM time
25~32000 (ms)
The duty cycle for a
square volume wave
FLANGER
Cycle of flanger shift is set in units
of 1/1 to 16/1 relative to 1 beat of
BPM
100~32000 (ms)
Amount of effect
increases when fader
is pushed upward.
When fader is at
minimum, only
original sound is
output
FILTER
Cycle of cutoff frequency shift is
set in units of 1/1 to 16/1 relative to
1 beat of BPM
100~32000 (ms)
Amount of effect
increases when fader
is pushed upward
PHASE
Cycle of phase effect shift is set in
units of 1/1 to 16/1 relative to 1
beat of BPM
100~32000 (ms)
Amount of effect
increases when fader
is pushed upward.
When fader is at
minimum, only
original sound is
output
PAN
Sets change time of 1/2 to 4/1 per
1 beat of BPM time
30~32000 (ms)
The sharpness for
pan between left and
right channel
min → most smooth
max → most sharp
PITCH Select -50%~+100% of pitch -50~+100 (%)
Amount of effect
increases when fader
is pushed upward
REVERB Select 0%~100% of reverb 0~100 (%)
Amount of effect
increases when fader
is pushed upward
SAMPLER
Select bank of recording/
playback of 4 beat source
7 sec. of max
recording for per
bank
Sets balance of
original sound and
recorded sample.
min → Original sound
max → Sample sound