8
EN
the cables firmly to the power hub at the proper
length (the wires should be just long enough to reach
the soldering point, facing outwards, and should not
be bunched up in front of the soldering point).
Ensure that there are no open circuits or
exposed wires when soldering the ESC cables.
•
It is recommended that you solder a power
connector onto the power hub.
•
DJI will release rmware updates when
available. Please refer to the ofcial DJI
website. An ESC Programmer is required for
ESC rmware updates. Please purchase this
from the DJI Online Store. Please refer to the
DJI Snail ESC Programmer User Guide for
details on rmware updates.
To Next Page
Loading...
