7
EN
2. Connect the signal cable to your ight controller.
The signal cable’s white wire transmits the control
signal; the black wire is for GND.
3. Connect the motor to the ESC. Test the motors and
ensure that the rotation direction of each motor is
correct. You can reverse the rotation direction by
swapping the positions of any two cables.
4. A PWM signal cable is also used to connect to a
PC to update rmware.
Connecting to the
ight controller
PDB
Power Cables
ESC
Motor
Signal Cable
The outer power pads are for the black GND cables.
The inner power pads are for the white VCC cables.
Make sure you solder them correctly. Try to solder
To Next Page
Loading...
