6
EN
Gain Value Settings
The 430 Lite ESC features a square wave drive. To
achieve optimal sensitivity, adjust the gain values
according to your ight control system and frame
before use. The table below shows typical gain
values used with the DJI NAZA
TM
-M V2 ight control
system and the DJI F450 multirotor ying platform,
at a takeoff weight of 1.3 kg.
Basic Attitude
Max Angular
Velocity
Pitch Roll Yaw Vertical Pitch Roll Pitch Roll
85% 85% 100% 100% 95% 95% 300 300
Connecting the ESCs
Tools Required: Power distribution board (PDB),
electric soldering iron and soldering tin.
1. Solder the black GND cable and white VCC cable of
the ESCs to the pads on the PDB as shown. Make
sure the solder is rmly attached to the power pads
and that there is no possibility for a short circuit.
To Next Page
Loading...
