dji CHX503-7000 - Updating Firmware; Firmware Update Procedures

10
©
2021 DJI All Rights Reserved.
EN
Solid green /
The battery in the corresponding position to the
number is fully charged
Blinks yellow three
times continuously
/
The temperature of the battery in the corresponding
position to the number is too low and the battery
station has stopped charging
Blinks yellow four
times continuously
/
The temperature of the battery in the corresponding
position to the number is too high and the battery
station has stopped charging
Blinks red once
continuously
Beeps once
continuously
The battery in the corresponding position is not
correctly connected or an unauthorized battery is
connected. This warning will only appear 10 seconds
after the battery is connected
Blinks red twice
continuously
Beeps twice
continuously
The connector short-circuited. Check the battery or
the battery station
Solid red
Beeps three times
continuously
Critical error detected
The warning indicator will light up if one of the following problems occur while using the battery station:
Warning Indicator Warning Sound Description
Solid yellow / Main board is abnormal and the power is limited
Blinks yellow once
continuously
/
The CPX503-3000 switching power supply is
abnormal and the power is limited
Blinks red once
continuously
/
The CPX503-3000 switching power supply is
unavailable or the fan stalled
Blinks red once
continuously
Beeps once
continuously
The CPX503-3000 has experienced a critical error
and there is no output
Solid red
Beeps twice
continuously
Main board is abnormal and unavailable
If there are any abnormalities, connect the battery station to a remote controller and run the DJI
MG or DJI Agras app to check more information. If the app indicates that a module is abnormal or
broken, contact DJI or a DJI authorized dealer.
Updating Firmware
FollowtheinstructionsbelowtoupdatethermwareusingtheremotecontrollerorDJIAssistant2
forMG.Userswillbenotiedthroughtheappwhenrmwareupdatesareavailable.
Using Remote Controller
1. Connect the battery station to a remote controller using a USB-C cable and connect the battery
station to a power outlet.
2. Power on the remote controller and press the power button on the operation panel to power on
the battery station.
3.RuntheDJIMGorDJIAgrasappandfollowthepromptstoupdatethermware.Makesurethe
remote controller remains connected to the internet while updating.