Need help?Do you have a question about the dji FlameWheel550 F550 and is the answer not in the manual?
Warning to maintain safe distance from obstacles, people, and hazards.
Caution against touching rotating motors and propellers to prevent serious injury.
Advice against exceeding the multi-rotor's load capacity.
Pre-flight check for secure installation of propellers and motors.
Ensure correct propeller rotation direction for proper flight.
Pre-flight inspection of all parts for good condition; avoid old or broken components.
Recommendation to use DJI-approved parts for compatibility and performance.
Instructions for soldering ESCs to the designated power pads on the bottom board.
Emphasizes proper insulation of soldering points to prevent short or open circuits.
Instruction to ensure the power pads are oriented facing upwards during installation.
Guidance on verifying and correcting motor rotation direction by adjusting wire connections.
Apply appropriate force when installing screws to avoid thread damage.
Recommend using screw glue for secure installation of screws.
Ensure neat wiring management to prevent wires from being cut by frame or propellers.
Advise to smooth the edges of the boards if they are rough or sharp.
Propellers should be installed only after the autopilot system configuration is complete.
Verify propeller rotation direction matches the provided diagram for correct operation.
To Next Page
General