dji OT-213 - Updating Firmware; Specifications

7
Descriptions of Other Blinking Patterns
Connection Status LED
Charging Status LED
Descriptions
Blinks red three times
rapidly
Blinks red three times
rapidly
Battery level is low
and device is about to
power off
Blinks red and green
alternatively
Blinks red and green
alternatively
Updating Firmware
Solid red Solid yellow
There is an error and
the Wireless Mic
must be powered on.
Contact DJI Support if
the issue persists.
Updating Firmware
The Do-It-All Handle must be attached to DJI Pocket 2 in order for the
Wireless Mic to connect to DJI Pocket 2 to update its firmware. If an update
is available, the firmware of the Do-It-All Handle will be updated first.
Afterwards, the Wireless Mic links and connects with the Do-It-Handle. A
prompt will appear onscreen with instructions on how to update the firmware
of the Wireless Mic.
Refer to the DJI Pocket 2 Do-It-All Handle User Guide for more
information on how to update firmware.
DO NOT operate the DJI Pocket 2, Do-It-All Handle, or Wireless
Mic while updating firmware. Otherwise, the update may fail.
Specifications
Transmission Type 2.4GHz digital frequency
Polar Pattern Omnidirectional
Frequency Range 50Hz - 20kHz
Maximum SPL 130dB SPL 10% THD; 120dB 1% THD
Battery Life
Analog Input
Up to 7 hours
3.5mm input
External Mic Input 20Hz - 20kHz
Acoustic Principle Pre-polarized pressure transducer
Equivalent Input Noise 24 dB SPL (A-Weighted)
Dynamic Range SPL-Equivalent Input Noise (Mic Preamplifiers)