dji Phantom 1 User Manual

DJI Phantom 1 & FC40 setup – Getting Started Guide
Copyright - Droneflyers.com - 2016
RTH – Return to Home – Failsafe programming of the Naza
ATTI – Altitude hold mode on the NAZA F/C – this does away with the use of the GPS and
gives you semi-manual control.
Assemble Quadcopter and Install Camera on FC40
Insert microSD card. Download the DJI app, turn on and connect to camera. Note – the plain
Phantom 1 does not come with a camera, so this step should be ignored for that model.
Charge the camera using the microUSB connector on it.
Here is a basic assembly video:
The propeller guards are a highly recommended accessory – especially for those without a lot
of Phantom experience.
NOTE: The FC40 will work and fly fine without the camera attached or turned on. Newbies
may want to start this way to avoid crashes which could damage the cam.
Phantom Software Installation and Upgrading
(for safety, do this with the propellers removed – see picture below)

dji Phantom 1 Specifications

General

Product color	Red, White
Frequency band	2.4 GHz
Maximum operating distance	1000 m

Weight and Dimensions

Width	350 mm
Height	190 mm