EasyManua.ls Logo

dji RC Plus

dji RC Plus
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mode 2 / 美国手 / 美國手 /
モード
2 /
모드
2 / Modus 2 / Modo 2
/ Mode 2 / Modalità 2 / Stand 2 / Modo 2 / Modo 2 / Режим 2
6
1
Start/stop motors: perform combination stick command.
2
Takeo: slowly push the left control stick (Mode 2) up to take
o.
3
Landing: slowly push the left control stick (Mode 2) down until
the aircraft lands. Hold for three seconds to stop the motors.
1
启动 / 停止电机:执行掰杆动作。
2
起飞:缓慢向上推动油门杆(美国手为左摇杆)飞行器起飞。
3
降落:向下拉动油门杆(美国手为左摇杆)至飞行器落地,在
最低位置保持 3 秒,电机停止。
1
啟動 / 停止馬達:
執行綜合控制桿指令
2
飛:
緩慢向上推動油門桿(美國手為左搖桿)使航拍機起飛。
3
降落:
向下拉動油門桿(美國手為左搖桿)直到航拍機落地,
在最低位置保持
3
秒,馬達停止。
1
モーターの始動/停止:コンビネーション
スティック
コマ
ンド(
CSC
)で実行します。
2
離陸:左の操作スティック(モード
2
)をゆっくりと上に倒
して離陸させます。
OR
1
2
3
3
着陸:左の操作スティック(モード
2
)をゆっくりと下に倒
して、機体を着陸させます。
3
秒間そのまま保持すると、モ
ーターが停止します。
1
모터 시동 / 중지 : 스틱 조합 명령을 수행합니다.
2
이륙 : 왼쪽 조종 스틱을 천천히 위로 밀어 ( 모드
2
) 이륙합니다 .
3
착륙 : 기체가 착륙할 때까지 왼쪽 조종 스틱을 천천히 아래로 밉니다
( 모드
2
).
3
초 동안 누르고 있으면 모터가 정지합니다 .
1
Ein-/Ausschalten der Motoren: Steuerknüppel-Kombinations-
befehl (Combination Stick Command, CSC) ausführen.
2
Abheben: Den linken Steuerknüppel (Modus 2) langsam nach
oben drücken.
3
Landen: Den linken Steuerknüppel (Modus 2) langsam nach
unten drücken, bis das Fluggerät landet. Halten Sie ihn drei
Sekunden lang nach unten gedrückt, um die Motoren auszu-
schalten.
1
Arrancar/detener motores: ejecute el comando de
combinación de palancas.
2
Despegue: empuje lentamente la palanca de control izquierda
(Modo 2) hacia arriba.
3
Aterrizaje: empuje lentamente la palanca de control (Modo
2) izquierda hacia abajo hasta que la aeronave aterrice.
Manténgala así durante tres segundos para detener los
motores.
1
Démarrer/couper les moteurs : eectuez une commande de
joystick combinée.
2
Décollage : poussez lentement le joystick gauche (Mode 2)
vers le haut pour décoller.
3
Atterrissage : poussez lentement le joystick gauche (Mode 2)
vers le bas jusqu’à ce que l’appareil atterrisse. Maintenez
pendant trois secondes pour couper les moteurs.
1
Avvia/Arresta motori: eseguire il comando a stick combinati.
2
Decollo: spingere lentamente lo stick di comando sinistro
(Modalità 2) verso l’alto per decollare.
3
Atterraggio: spingere lentamente lo stick di comando sinistro
verso il basso (Modalità 2), fino a quando l’aeromobile non
atterra. Tenere premuto per tre secondi per arrestare i motori.
1
Start/stop-motoren: voer gecombineerde joystickopdracht uit.

Other manuals for dji RC Plus

Related product manuals