Ronin-M
User Manual
26
©
2015 DJI. All Rights Reserved.
The thumb controller and the remote operator control sticks have a Deadband, Maximum Speed, and
Smoothing adjustment, all of which can be set independently.
Endpoint: Pan axis endpoints can be adjusted independently for left and right movement when used with
a remote control or the thumb controller. Tilt axis endpoints can be adjusted independently for up and
down movement when used with a remote control or the thumb controller.
If the ability to rotate 360˚ on the pan axis is needed, simply adjust the endpoints for pan to 0. If endpoints
are set to 0 for 360˚ pan ability, then the "Test Pan Endpoint" function will not change the pan axis.
The pan and tilt endpoints can be tested. Ensure that the camera is unobstructed when clicking the test
buttons.
Controller Priority: If both input devices simultaneously send control signals to the gimbal, the input from
the selected controller will take priority and will control the device at that given time.
Pan/Tilt Remote Speed Adjustment: Click to choose combined or independent settings.
Speed Toggle Presets: These presets will allow you to change the SmoothTrack speed remotely. If
the remote control is turned on, the Speed Toggle Presets for SmoothTrack will take precedence
Viewer Menu: The Viewer Menu provides essential live data for monitoring the Ronin-M’s electronics and
feedback from the motors. Power is indicated for each axis. The current angle of each axis is also indicated.
Calibrate System: Calibrate System is only used if you notice any kind of drift in any of the axes. To
calibrate the system, place the Ronin-M on the tuning stand and make sure it is completely steady.
Ensure a 90 degrees movement of the camera with the lens pointing straight down is possible without
any interference from video monitor wires during the movement. Then tap the Calibrate System button
and let the process nish before picking up the Ronin-M. Do not move the Ronin-M during calibration.
Restart the Ronin-M after calibration is complete.
Auto Tune Stability: The Auto Tune Stability button allows for automatic adjustment of each motor’s
stiffness settings (as relayed from the sensors and interpreted by the Ronin-M) to accomplish an
optimized setting.
Default: Click here to restore all settings to the factory defaults.
2. Control
DJI PC / MAC Assistant Tuning
To Next Page
Loading...
