dji RONIN-M - Page 9

Ronin-M
User Manual
©
2015 DJI. All Rights Reserved.
9
Getting Started
Socket
DJI Intelligent Battery Functions
Balanced Charging Automatically balances the voltage of each battery cell during charging
Capacity Display Displays current battery levels
Overcharge Protection Charging stops automatically when the battery voltage reaches 16.8V,
preventing overcharge damage
Over-Discharge Protection Discharging stops automatically when battery voltage reaches 12V,
preventing over-discharge damage
Short-Circuit Protection Automatically cuts power supply when a short circuit is detected
Sleep Protection Sleep mode is activated after 10 minutes of inactivity, saving power
Charging Temperature
Detection
The battery will charge only when the temperature is between 0℃ and
55˚C
DJIIntelligentBatterySpecications
Type LiPo
Capacity 3400mAh, 14.8V
Charging Environment Temperature 0 °C ~ 45 °C
Operating Environment Temperature -15 °C ~ 50 °C
Charging/Discharging Environment Relative Humidity <80 %
Read the user manual, disclaimer, and battery warnings before use. Users take full
responsibility for all operations and usage.
Always use DJI approved chargers. DJI takes no responsibility for any consequences
resulting from the use of non-DJI approved chargers.
Charging the DJI Intelligent Battery
1. Connect the charger to a wall socket (100-240V, 50/60Hz). Use one of the included plug
adaptors, if necessary.
2. Connect the DJI Intelligent Battery to the charger.
3. The battery level indicator lights display the current charge level as the DJI Intelligent Battery
charges.
4. The DJI Intelligent Battery is fully charged when the battery level indicator lights turn off and the
indicator light on the charger turns green. Disconnect the battery from the charger when charging
is complete.