dji Ronin-S - Ronin-S Component Diagram

EN
©
2018 DJI OSMO All Rights Reserved.
5
RONIN-S Quick Start Guide
3. Attach the camera dovetail plate and lens support*.
4. Slide the camera onto the camera mounting base. When a rough back and forth balance is
reached, toggle the lever to the locked position after the safety lock is engaged.
5. Attach the optional hot shoe module to the top of the camera.
1
2
3
4
5
2
1
Balancing
1. Balancing the Vertical Tilt
a. Rotatethetiltaxissothatthecameralensispointingup.Holdthetiltaxismotortoensurethe
rollaxisremainshorizontalandcheckifthecameraistoporbottomheavy.
b. Loosentheknob
1
onthetiltmotorandadjustthecamerabalance
2
untilthecamerastays
stillwithouttiltingitupordown.
c. Tightentheknob.
2
1
* For the best results during setup, use the lens support whenever possible.