dji RONIN-SC - Introduction; Ronin-SC Diagram

b
ottomheavy.
c. Loosentheknobonthetiltmotorandadjustthecamerabalanceuntilthecamerastays
stillwithouttiltingupordown.
d. Tigh tentheknob.


2. BalancingDepthfortheTiltAxis
a. Rotatethetiltaxissothatthecameralensispointingforward.Checkifthecameraistop
orbottomheavy.
b. Loosentheknobunderthecameramountingbaseandthenadjustthecamerabalance
untilthecamerastaysstillwhenrotatingthetiltaxis45° upwardsordownwards.
c. Tightentheknob.Theslideronthedovetailplateisusedtorecordthebalancepositon,
tightenthesliderwhenitclosedtothemountingbase.


3. BalancingtheRollAxis
a. Lockthetiltaxisandthenunlocktherollaxis.Checkthedirectioninwhichtherollmotor
swings.
b. Loosenthe knobon thecamera mountingbase, and then adjustthe base positon until
thecamerastaysstill.
c. Tightentheknob.Ifthecameramovesforwardbyaccident,movethecamerabackward
untilthesliderisclosedtothemountingbase.
