dji SPARK Manual

Waypoint Action
Here you can set what action (take pics, start recording…) the drone will perform
after reached the waypoint (also after complete the heading and gimbal
rotations), before proceed to the next waypoint.
Waypoint Action require “Stop On Each” as mission flight mode
Speed
The speed that you set here, is the one that the drone will use from here to the
next waypoint.
notes:
• only the speed that you set on the first waypoint will be also used as speed to
reach it from the point you start the mission
• the speed can also modified while the mission is running acting on the “pitch”
on the remote controller. if you push the “pitch” back enough the drone not
only go slower, will also go back on the mission path. When you leave the pitch
stick on the center the drone will continue the mission at the set speed.
• in “mission configuration” (see below) you can choose a fixed speed for the
entire mission instead of defining it for each waypoint
• if you set “0” speed, the drone will stay stationary and will move only with the
“pitch” stick on the remote controller
Note: altitude and position of all waypoints must be within the drone altitude and
range limit, otherwise the mission will not run (see “Flight Limit settings” above)

dji SPARK Specifications

Operating Environment

max speed	31 mph (50 kph)
operating temperature	32° to 104° F (0° to 40° C)
charging temperature	41° to 104° F (5° to 40° C)

Camera

sensor	1/2.3” CMOS
effective pixels	12 Megapixels
video recording modes	FHD: 1920×1080 30p

Power

charger input	100-240 V, 50/60 Hz, 0.5 A
charger output	5 V 3 A / 9 V 2A / 12 V 1.5 A
battery capacity	1480 mAh

Remote Control

operating frequency	2.4G / 5.8G
max transmission distance (Wi-Fi)	100 m (Distance), 50 m (Height)
max transmission distance (Remote Controller)	2000 m

Weight and Dimensions

weight	300 g
dimensions	143×143×55 mm