dji spreading wings s900

Spreading Wings S900
User Manual
©
2014 DJI. All Rights Reserved.
15
If right and left servo cables are reversed, the landing gear will not function properly.
Connect all wires carefully and neatly to avoid cable damage caused by frame edges.
Connecting the ight controller and landing gear
1. Connect the left servo (between M3 and M4) cable to the “L” port of the landing gear control board.
2. Connect the right servo (between M5 and M6) cable to the “R” port of the landing gear control board.
3. For the A2 ight control system, connect the F1 port of the ight controller to the “IN” port of the landing
gear control board. Other ight control systems connect a 2-position channel receiver to the “IN” port.
Mounting Electronics and Wiring
Right Servo Connector Left Servo Connector
R
L
IN
R
L
IN
F1
R
L
IN
R
L
IN
F1