dji T30 - Introduction; In the Box; Overview; Installation

EN
© 2021

DJI All Rights Reserved.
3
In the Box
The T30 Spreading System and T10 Spreading System are similar in appearance, but the spread tanks are dierent
sizes. Unless otherwise specied, the illustrations in this document use the T30 Spreading System 3.0 as an example.
Overview
Installation
• Make sure to remove the Intelligent Flight Battery from the aircraft before installation.
• Operate with caution to avoid injury caused by sharp or moving mechanical parts.
Spread Tank
Spreader
Spreader Lock Knob
Spinner Disk
Control Module
Cable
Weight Sensors
Introduction
The T30/T10 Spreading System 3.0 is compatible with the Agras T30/T10 aircraft respectively and oers ecient and
reliable spreading operations.
The spreading system comes up with a built-in stirring device and hopper gate control structure to prevent material
blockages and improve operating accuracy and reliability. The weight sensors monitor the weight of the remaining
material in the spread tank in real time while the control module improves the accuracy of the spread rate control and
empty tank warning. Fenders are included in the packaging and can block spreading material that ies upward from
damaging the propellers.
Users can congure spreading settings in the DJI Agras app and create specic templates for dierent materials in order
to meet dierent requirements. The app also provides warning prompts for an empty tank as well as for abnormalities in
rotational speed, temperature, and hopper outlet size.
Spreading System 3.0 × 1 Spare Spinner Disk × 2 Fender Pair × 1 Small Flow Hopper Gate
× 1
Fender Screw × 4 Stopper
(for T30 only)
(for T10 only)