To Next Page

To Previous Page

If you are updating your aircraft using DJI Assistant 2 or the DJI mobile app, the battery that is

powering the aircraft will be updated if the firmware update includes a battery update or if the

battery firmware is not on the latest version. Assuming there was a battery update as part of the

firmware update, when you place a non-updated battery into the drone you will get a notification

stating inconsistent firmware and allowing you to update the battery based on the aircraft’s

current firmware. In this case, no additional connections to the internet or DJI Assistant 2 are

required for this battery update with an already updated aircraft.

You can also update the firmware of your TB60 batteries (used with the M300 RTK), by placing

them in the BS60 Battery Station and connecting the Smart Controller Enterprise to the battery

Questions and Answers:

Need help?

Do you have a question about the dji TB60 and is the answer not in the manual?

dji TB60 Specifications

General

Capacity	5935 mAh
Voltage	52.8 V
Battery Type	LiPo 12S
Net Weight	Approx. 1.35 kg
Charging Temperature	5°C to 40°C
Weight	Approx. 1.35 kg
Charging Temperature Range	5°C to 40°C
Compatible Models	DJI Matrice 300 RTK
Operating Temperature	-20°C to 50°C
Discharging Temperature Range	-20°C to 50°C