dji TB60 User Manual

For aircraft with a dual-battery design such as the M300 RTK and M200 Series, mark two
batteries as a pair and continue using them as a pair (charge and discharge them together) to
maximize the service life and ensure flight performance. Using this method the pairs will
maintain very similar internal resistance.
In a low-temperature environment, the TB60, TB55, TB50, and M2E batteries have a
self-heating feature. Once the battery is installed on the aircraft and the power is turned on, if
the battery’s temperature is low, it will automatically self-heat to keep the temperature at about
60.8°F to 68°F (16 °C to 20 °C). However, this self-heating will consume the battery power so
the flight time will be reduced. Therefore, to maximize flight time or when using batteries without
a self-heating feature such as the Phantom 4 models, it is suggested to heat the battery with an
external heat source such as warm air inside a vehicle.
The self-heating function for equipped batteries can also be manually turned on by pressing and
holding the power button (see below chart). This will keep the battery at an ideal temperature
range for 30 minutes. The self-heating function can be turned off by holding the power button.
Battery Type
To Turn Manual Self-Heating On
To Turn Manual Self-Heating Off
TB60
Hold for 5 seconds
Hold for 5 seconds
TB55
Hold for 4 seconds
Hold for 2 seconds
TB50
Hold for 4 seconds
Hold for 2 seconds
M2E
Hold for 5 seconds
*Battery will maintain an ideal
temperature for 20 minutes

dji TB60 Specifications

General

Capacity	5935 mAh
Voltage	52.8 V
Battery Type	LiPo 12S
Net Weight	Approx. 1.35 kg
Charging Temperature	5°C to 40°C
Weight	Approx. 1.35 kg
Charging Temperature Range	5°C to 40°C
Compatible Models	DJI Matrice 300 RTK
Operating Temperature	-20°C to 50°C
Discharging Temperature Range	-20°C to 50°C