EasyManuals Logo

dji ZENMUSE P1 Quick Start Guide

dji ZENMUSE P1
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
11
CHS
安装云台相机
1. 移除 P1 负载的云台保护盖。
2. 按住飞行器的云台相机解锁按钮,移除保护盖。
3. 对齐云台相机上的白点与飞行器接口的红点,并嵌入安装位置。
4. 旋转云台相机接口至锁定位置(红点对齐),以固定云台。
如无法安装云台 , 请检查插头是否被意外扭转 , 若由于意外扭转导致不平齐,请手动拨平
后再装入云台。
如需移除云台相机,请先按住飞行器的云台相机解锁按键,再旋转移除云台相机。
存储时请连同镜头一起放进收纳箱,不建议反复拆装镜头。
建议关闭飞行器电源后,再移除云台相机或镜头。
飞行器存储与运输过程中,需要将云台相机从飞行器上取下,否则将导致减震球使用寿命
降低甚至损坏。
飞行器起飞前,请检查确保云台相机 SD 卡槽的盖子已扣合,否则可能卡住云台轴臂,导
致云台电机过载。
相机功能
遥控器控制
MATRICE
TM
300 RTK 遥控器为例,遥控器左、右拨轮分别控制云台的俯仰和平移角度;通过拍照、
录影按键控制相机拍照和录影;五维按键可调节 EV 值;自定义按键 C1 可使云台回中,而自定义按键
C2 可切换主辅画面。
1
2
3
4
5
2 3
4
11

Other manuals for dji ZENMUSE P1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the dji ZENMUSE P1 and is the answer not in the manual?

dji ZENMUSE P1 Specifications

General IconGeneral
Country of originChina
Power consumption (max)20 W
Product colorBlack
Compatible productsDJI Matrice 300 RTK
International Protection (IP) codeIPX4
Operating temperature (T-T)-20 - 50 °C
Operating relative humidity (H-H)-20 - 60 %
Megapixel45 MP
Maximum image resolution8192 x 5460 pixels
ISO sensitivity100, 25600
Image stabilizerYes
Maximum aperture number16
Minimum aperture number2.8
Field of view (FOV) angle63.5 °
Fastest camera shutter speed1/2000 s
Slowest camera shutter speed1 s
Compatible memory cardsSD
Maximum memory card size512 GB
Maximum frame rate60 fps
Video formats supportedMOV, MP4
Maximum video resolution3840 x 2160 pixels
Mechanical pan range-320 - 320 °
Mechanical roll range-55 - 55 °
Mechanical tilt range-130 - 40 °
Wi-Fi-
Weight and Dimensions IconWeight and Dimensions
Depth129 mm
Width166 mm
Height198 mm
Weight800 g

Related product manuals