My iPod does not appear to be charging when it’s connected to TransDock
micro.
Make sure TransDock micro is securely positioned in your car’s power outlet.
You may also check to ensure that the connector cable is all the way
into the iPod’s dock connector.
If I leave TransDock micro plugged into my car’s power outlet, will it drain my
car battery?
Probably not, but it’s always a good idea to unplug anything when leaving your
car for a long period of time.
NOTE: Your TransDock micro will continue to draw power from your car’s
battery as long as a device is attached.
Can I use TransDock micro with other devices?
No, TransDock micro is designed specifically for use with iPods.
| 15
Frequently Asked Questions
My music is playing, but there seems to be a lot of static.
Use IntelliTune to automatically find the optimal frequency to broadcast your
iPod over your car’s FM stereo. Then, tune your car’s FM stereo to the frequency
displayed on TransDock micro.
You may also try setting the Listening Mode to Mono, which will improve the
clarity of TransDock micro’s signal.
My radio will only scan/seek to occupied FM stations.
Many car radios default to scan/seek mode for tuning, so they automatically tune
to a radio station. Most of these radios can be switched to manual tuning (consult
your car or radio manual on how to do this).
My music sounds overdriven and distorted.
Be sure that the FM station you’re using is still unoccupied as you drive
through different areas. FM signals can intrude on an unused frequency.
Be sure to set your iPod EQ to Off and adjust your car’s bass and treble controls
to 0. Then you can experiment with adding bass and treble to your desired level.
However, we highly recommend that you start with everything at 0.
14 | DLO TRANSDOCK MICRO USER GUIDE
To Next Page
Loading...
Need help?
General
