Revision: 0
FlexxPump 500 DLS
Continuation sheet
09
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
7. Operation and settings
7.1 General information
What you should know about operating and setting the FlexxPump 500 DLS:
For operation, the FlexxPump 500 DLS must be integrated into a control system
(PLC) and must be commanded and controlled via the PLC. The FlexxPump 500 DLS
delivers one or more strokes (one stroke = 0.15 cm³) depending on the signals of the
external control (PLC). Depending on the internal status of the FlexxPump 500 DLS
(e.g. cartridge empty), dierent output signals are issued by the FlexxPump 500 DLS.
If you have any questions about your application and the correct settings for Flexx-
Pump 500 DLS, please contact the manufacturer (chapter I.II).
Make sure that your PLC program is correct for your application and that the lubricati-
on point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate the FlexxPump 500 DLS.
If this is not the case, change your PLC program accordingly.
To use the FlexxPump 500 DLS, it rst has to be properly mounted and installed. The
installation is very simple and described in detail in chapter 6.2.
If you order a special version of the FlexxPump 500 DLS from the factory, the infor-
mation on the supplement sheet is decisive for you!
To Next Page
Loading...
