What to do if my DMG Dental equipment switches off by itself?
If your DMG Dental equipment switches off by itself, first remove any cured material from the cartridge. Next, ensure a new mixing tip is correctly installed. Finally, turn the device off using the main switch for at least 5 seconds before restarting.
What to do if my DMG Dental equipment starts but no impression material is delivered?
If your DMG Dental equipment isn't delivering impression material, first ensure that a new mixing tip is correctly installed. Also, if using foil bags, verify that the cartridge has been filled and that the foil bags are sufficiently open.
What to do if DMG MixStar eMotion dispenses impression material, but the mixing component doesn’t rotate?
If your DMG Dental equipment's mixing component doesn't rotate after dispensing impression material, check whether the mixing shaft properly engages with the mixing tip. If the hexagonal opening of the mixing tip is damaged, attach a new one. Also, check the electrical connection (115 V / 230 V).
Why is the flow of the impression material too slow in my DMG MixStar eMotion?
If the flow of impression material from your DMG Dental equipment is too slow, ensure that the impression materials are at room temperature (min. Recommended operating + 18 to + 40 °C / + 64 to + 104 °F). If using foil bags, make sure they have been inserted correctly and allow 11 seconds for piston retraction during cartridge exchange.
How to troubleshoot a DMG MixStar eMotion that does not start?
If your DMG Dental equipment does not start, check that the power cable is securely connected to both the device and the power socket. Also, inspect the fuses and replace them if necessary, paying attention to the specifications on the rating plate.
General| Brand | DMG |
|---|---|
| Model | MixStar eMotion |
| Category | Dental equipment |
| Language | English |
To Next Page
